The textile bottom is designed to be placed in the right arm of the bear (seen from the back), when the Thing is attached on the back, with the USB cable going downwards.

This mean that on the right arm of the bear on the top, next to the head is a stick out, which will be connected to 5V on the board’s right side. The stick out at the paw should be connected to GND, and the one in the middle to pin 14.

However, first we will see if we can make it work on our current circuit using our current code – looking up whether it is friday today?

When the textile button works (it execute the programming code), then sew is on the Bear’s right arm with regular thread. When attached – test it again (using tape) for the breadboard setup.